Timber floors · Acoustic overlay board

Acoustica CHIP 28/32

An economical acoustic floating floor for upgrading timber separating floors: 18 mm or 22 mm tongue-and-groove P5 chipboard with a pre-bonded 10 mm resilient foam layer.

53 dBAirborne DnT,w + Ctr (CHIP 28, site test)
52 dBImpact L′nT,w (CHIP 28, site test)
28 / 32 mmBoard thickness
1.44 m²Sheet · 600 × 2400 mm

Why CHIP 28/32

  • Low-cost product, ideal for general and new domestic separating floor upgrades
  • Good impact and airborne sound reduction
  • Ideal under floated wood, laminate, carpets and carpet tiles
  • Economical system for conversion projects

Applications

Domestic dwellings, offices, hotels, conference centres, leisure centres, schools, restaurants and showrooms.

Tested build-up

  1. Acoustica CHIP 28/32
  2. Existing subfloor
  3. Flat perimeter edging strip detail
  4. 100 mm, 45 kg/m³ acoustic slab
  5. Resilient bars and 2 layers of 15 mm acoustic plasterboard
  6. 225 mm deep timber joists

Specification

Product codeCHIP 28: 1071 · CHIP 32: 1074
Board18 mm or 22 mm T&G P5 chipboard with a pre-bonded 10 mm resilient foam layer
CHIP 28 sheet28 × 600 × 2400 mm (1.44 m²) · 17.8 kg
CHIP 32 sheet32 × 600 × 2400 mm (1.44 m²) · 21.8 kg
Site test dataSITMA-accredited Test No. 1184 (CHIP 28): airborne DnT,w + Ctr 53 dB, impact L′nT,w 52 dB, on the construction shown above
Method of compliancePCT / PT (Scotland)
Floor finishesReady for laminates, carpets and carpet tiles. Tiling and vinyl may need additional floor preparation.
Ancillary productsFlat edging strip 50 lm × 75 mm × 5 mm (1490) · Approved adhesive 1 litre (1196) · Acoustic sealant 310 ml (1027)

Installation at a glance

Before you start

  • Keep boards dry and acclimatise for at least 24 hours
  • Subfloor or joists must be flat, dry and free from debris
  • Lay as a floating floor, with no mechanical fixings
  • Prepare wall surfaces down to subfloor level

Laying

  • Fit 5 mm perimeter edging strip to all walls, uncompressed
  • Fully glue all T&G joints with the recommended adhesive
  • Stagger board joints and seal any minor gaps with acoustic sealant
  • Leave a 5 mm sealed gap at main entrance thresholds

After laying

  • Keep off the floor for 24 hours while the adhesive cures
  • PVA adhesive won’t cure below 5 °C
  • Penetrations through the floor and ceiling must be detailed site by site

Need technical advice or a price?

Our team can help with specification and installation queries.

Call 07818 542495Email us

Information is correct to the best of our knowledge. Please contact us before starting works for the latest information and confirmation of the specification.

© Copyright 2026 - Acoustica Sound Proofing